Horizon Global PRO Serie Manuel D'instructions page 70

Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the ~4" between parallel
rows of spot welds where the bed sill sits.
2. Cut 1" from top flange of brackets. Under bed, mount brackets with flanges facing out.
3. Put rear brackets on Row 3 for '97 to Present models. Put brackets on Row 4 for '96 and Earlier models.
Cut Off
1"
Frame Bracket
NOTE:
Must install center bolt in
one of the center holes in
each rail.
Check to make sure center
bolt does not interfere with
bed sill.
King Pin Centered over Axle
Front
of
Vehicle
Long bracket
1/4
*
1/4
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Horizon Global America Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the
©
2006,2007,2008,2009,2010,2011,2012,2013, 2014, 2017 Horizon Global America Inc .
DODGE '94 to 2004 DAKOTA
Front
of
Vehicle
Side Bracket
1.5-3
2
responsibility of the installer to prevent damage due to installation.
SHEET 15 0F 19
Made in China
CAUTION!
Axle Center
1997 to 2004
Up to & Including 1996
CAUTION!
30035IN
Rear Edge of
Truck Bed
26" Long Box
and Short Box
Measure from Rear
Edge of truck bed to
rear edge of base rail.
Bed Sill
Drivers side Dakota Shown
Short brackets
*
1/4 2
*
1/4 2
1/31/2017
Optional weld
pattern
Rev. U