Horizon Global PRO Serie Manuel D'instructions page 67

2013 MODEL YEAR RAM 2500 HD (Dodge/Chrysler)
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Tube spacer and 4 1/2" carriage bolt used to attach through rearward Bed Sill (Row 3).
2. **Rib neck bolts will need to be pulled through access holes in frame with supplied pull wire (see below). Wire
extensions will need to be added on to the pull wires for the forward rib bolts.
3. Do not drill through both
walls of frame. Drill only
through wall of frame to
which bracket is mounted.
4. It is very important that
brackets in Row 2 are close to
rear side of Bed Sill as shown.
Due to dimensional instability in
Bed Sill placement with the
Dodge truck, interference could
result when drilling in Row 3.
Observe caution note below and
double check all areas prior to
drilling.
5. *Due to tubular frames
having thinner walls than
previous C channel
frames, extra caution
needs to be used when
mounting with the optional
welding.
Side Bracket
Front
of
Drivers side of
Vehicle
2500 Ram Shown
Long bracket
(driver's side)
outside of frame
1/4 1.5-3
*
1/4 2
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Horizon Global America Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the
©
2006,2007,2008,2009,2010,2011,2012,2013, 2014, 2017 Horizon Global America Inc .
Front
of
Vehicle
King Pin Centered
over Axle Center
Short bracket
(passenger's side)
outside of frame
responsibility of the installer to prevent damage due to installation.
SHEET 12 OF 19
Made in China
CAUTION!
Drill through
Bed Sill with
17/32" drill.
Open up hole
through truck
bed only with
1" dia. drill.
Drop tube
spacer through
hole in truck
bed to avoid
crushing Bed
Sill when
torquing 4-1/2"
carriage bolt.
Use provided tube spacer and 4-1/2"
carriage bolt to attach through Bed Sill
Bed Sill
Short bracket, (driver's side)
inside of frame
CAUTION!
30035IN
(without overload brackets)
Measure from rear
edge of truck bed to
rear edge of base rail.
R e a r e d g e o f
t r u c k b e d
NOTE:
Must install center bolt in
one of the center holes in
each rail.
Check to make sure center
bolt does not interfere with
bed sill.
Long bracket, (passenger's side)
outside of frame
1/4 2
*
1/4 2
**Access hole
(in bottom of frame)
1/31/2017
Optional weld
pattern
Rev. U