BH FITNESS YV25 Mode D'emploi page 13

16.-
Key to reduce rocking
vibration speed.
The rocking speed can also be
adjusted by using the buttons on the
right handlebar (Z), Fig.3.
17.-
USB
key.
18.-
P1
selection key.
19.-
Manual program selection
key.
20.-
P2
selection key.
21.-
P3
selection key.
START-UP.-
Plug the mains cable (63) into the
socket (M) on the column, Fig. 2.
Plug the other end of the cable into
the electric wall socket (220V). Set
switch (L) to position (I) Fig. 2.
Press the START/STOP button to stop
the platform.
MANUAL PROGRAM.-
Set switch (L) to
position (I), Fig.
2, the characters
shown in the
diagram will light
up.
Press the
START/STOP
key or the
ON/OFF buttons
on the left
handlebar (X) Fig.3, to start the
machine at a preset rocking vibration
program selection
automatic program
automatic program
automatic program
time of 10 minutes and rocking
intensity of 1.
Press the START/STOP button to stop
the platform.
TIME PROGRAMMING MODE.-
The exercise
minutes) is programmed with the
machine stopped by pressing keys 14-
15.
The time can also be set by using the
buttons on the right handlebar (Z)
Fig.3.
Press the START/STOP key and the
machine will start to operate based on
the programmed time settings.
Once the machine has started the
rocking intensity can be adjusted by
using keys 14-15 or the buttons on the
right handlebar (Z), Fig.3.
AUTOMATIC PROGRAMS.-
This monitor has 3 preset automatic
programs (P1; P2 and P3).
Refer to the
programs on the pages at the end of
this manual.
Press any of the P1-P2-P3 keys to
select the corresponding program.
Press the START/STOP key or the
ON/OFF button on the left handlebar
(X) Fig.3 to set the platform in motion.
Press the START/STOP keys or
ON/OFF to stop the platform.
USB USER PROGRAMS.-
This monitor has 6 user programs (U1;
U2; U3; U4; U5 and U6) which can be
used to vary the vibration frequencies
and times.
MODIFYING DATA IN USER
PROGRAMS.-
Do the following to modify the data
stored in user programs:
13
time setting
settings for
(0-20
these