Troubleshooting - Sonnenkonig WARMEPILZ CHROME GAZ Mode D'emploi

10 Troubleshooting

PROBLEM
GB
Pilot will not light
Pilot will not stay on
Burner will not light
Any changes or repairs to the unit must be performed by a qualified person.
Since the development of the produced equipment is progressing steadily, it may
happen that your product is minimally different from that described.
Possible Cause
– Gas valve may be OFF
– Tank fuel empty
– Opening blocked
– Air in supply system
– Loose connections
– Debris around pilot
– Loose connections
– Thermocouple damaged
– Gas leak in line
– Lack of fuel pressure
– Pressure is too low
– Opening blocked
– Control not turned on
– Thermocouple damaged
– Pilot light assembly bent
– Not in correct location
58
Solution
– Turn the gas valve ON
– Refil LPG tank
– Clean opening
– Remove air from lines
– Check all fittings
– Clean dirty area
– Tighten connections
– Replace thermocouple
– Replace line
– Tank nearly empty. Refill LPG tank
– Tank nearly empty. Refill LPG tank
– Clean the opening
– Turn control to ON
– Replace thermocouple
– Place pilot properly
– Position properly and tetry