Sonnenkonig WARMEPILZ CHROME GAZ Mode D'emploi page 57

Step 4
• Remove the 4 bolts from the burner.
• Put the gas hose through the post.
• Fix the burner unit to the post using the
4 bolts.
Step 5
• Check whether the connection of vertical
post and burner are assembled accordingly
and all bolts and nuts are tightened.
• Put 6 large flat washers as spacers onto
the reflector.
Step 6
• Fasten the reflector with 3 large flat washers
and 3 wing nuts.
Step 7
• Open the gas cylinder housing and rest it on
the base.
• Connect the regulator to the gas tank and
tighten it with the adjustable wrench.
• Connect the end of the gas inlet hose to the
regulator.
• Place the LPG tank onto the base.
Regulator
57
Bolts
Space of
the reflector
Wing nuts
Reflector
Gas tank
GB