Safety Instructions - Sonnenkonig WARMEPILZ CHROME GAZ Mode D'emploi

1 Safety instructions

Please read before first commissioning the safety instructions carefully and observe the
GB
safety instructions to prevent damage due to misuse, improper operation, and improper
environmental conditions to be avoided. Keep these for later reference .
Check the device after removing the packaging for damage . Do not put the unit in case
of suspected corruption in operation and consult a specialist. The recyclable packaging
material must not be stored or disposed accessible for young children , but must be
disposed of properly.
This appliance is only for the purpose for which it was explicitly developed , ie be used
for heating rooms . Any other use is regarded as improper and therefore dangerous . The
supplier is not liable for damage to persons and / or property damage due to an improper
or incorrect use.
Repairs to electrical appliances must only be carried out by trained personnel only .
Improperly performed repairs and alterations to the equipment can have dangerous con-
sequences for the user according to what the warranty will be rejected.
• For use outdoors or in amply ventilated areas. An amply ventilated area must have a
minimum of 25% of the surface area open.
• Do not use the patio heater indoors, as it may cause personal injury or property damage.
• This outdoor heater is not intended to be installed on recreational vehicles and/or boats.
• Installation and repair should be done by a qualified service person.
• Improper installation, adjustment, or alterations can cause personal injury or property damage.
• Do not attempt to alter the unit in any manner.
• Never replace or substitute the regulator with any regulator other than the factory-sugge-
sted replacement.
• Do not store gasoline or other flammable vapors or liquids in the heater unit.
• The whole gas system, including the hose, regulator, pilot and burner should be inspected for
leaks or damage before use. The appliance should be checked by a qualified service person.
• All leak tests should be done with a soap solution. Never use an open flame to check for
leaks.
• Do not use the heater until all connections have been leak tested.
• Turn off the gas valve immediately if smell of gas is detected. Turn the cylinder valve OFF.If
the leak is at the connection between the hose and the regulator: tighten the connection
and perform another leak test. If bubbles continue to appear the hose should be returned
to the place of purchase. If the leak is at the connection between the regulator and the
cylinder valve disconnect.
48