•
Clean the filter every two weeks.
1. Open Strainer Overlay
2. Take out filter.
3. Soak the strainer in warm water about 40 degrees Celsius and put
some neutral detergent in it, then rinse off the lotion and keep it dry in
a cool place.
4. Installation: Press the reverse step of the disassembly to install the
filter back.
Drainage mode
In general, there is no need to use the drainage tube, because the
evaporator of the machine will automatically evaporate water. If the
ambient humidity is very high, we need to use the drainage tube.
Automatic evaporation and drainage of condensed water
•
The machine can automatically evaporate condensing water and drain
out of the exhaust hose.
•
In the cooling mode, the machine does not need to connect the drain to
drain water, please ensure that the plug of the machine has been installed.
•
In the dehumidification or heating mode, the plug "A" in the drain hole
should be removed.
•
The drain plug "A" in the drainage hole should be removed and an
appropriate drainage pipe must be installed for continuous drainage.
CLEANING MAINTENANCE AND STORAGE
•
Before cleaning, be sure to disconnect the unit from any electric supply
outlet.
•
First clean the surface with a neutral detergent and wet cloth, and then
wipe it with a dry cloth.
•
Do not use gasoline or other chemicals to clean the unit.
•
Do not wash the unit directly.
•
If the conditioner is damaged, please contact the dealer or repair shop.
•
If you will not use the machine for a long time, it is better to open the
drain hose at the bottom and drain the unit thoroughly.
•
Store the unit in a dry place.
Air conditioner
EN
9