Cleaning & Maintenance - Tristar AC-5560 Mode D'emploi

CLEANING MAINTENANCE
• Before cleaning, disconnect the unit from any electric supply
outlet.
• First clean the surface with a neutral detergent and wet cloth, and
then wipe it with a dry cloth.
• Do not use gasoline or other chemicals to clean the unit.
• Do not wash the unit directly.
Air filter
• The air filter should be cleaned once every two weeks.
• Open the air inlet grille and take off air filter.
• Clean the air filter with neural detergent in lukewarm 40°C and
allow to dry (not in direct sunlight).
• Re-install the air filter into the inlet grille.
TROUBLESHOOTING
Troubles Possible Causes
The unit does not start • Water full indicator
when pressing power lamp blinks and water
button. tank is full.
• Room temperature is
higher than the setting
temperature.(Electric
heating mode)
• Room temperature is
lower that the setting
temperature.(Cooling
mode)
The unit doesn't cool
enough.
Auto Power-Off in heating
mode.
Noisy.
Suggested Remedies
• Drain the water out of
the water tank.
• Adjust the
temperature.
E0 Code.
E2/E4 Code.
Instruction manual
• The doors or windows • Make sure all the
are not closed. windows and doors
• There are heat are closed.
sources inside the • Remove the heat
room. sources if possible.
• Hot air exhaust hose • Connect or clean the
is not connected or hot air exhaust hose.
blocked. • Reset the
• Temperature setting is temperature.
too high. • Clean the air inlet.
• Air inlet in blocked.
• Heating protection, • Allow room
when the temperature temperature to cool
at the air outlet before re-starting the
exceeds 70 degrees, unit.
the unit will power off
automatically.
• The ground is not • Place unit on a flat,
level or not flat level ground if
enough. possible.
• The sound comes
from the flowing of the
refrigerant inside the
air conditioner.
• Room temperature • Replace room
sensor failed. temperature sensor.
• Water tank full • Please empty the
water tank.
EN
11