Clear Dust Chute/Scoop - skilsaw SPT99 Consignes D'utilisation/De Sécurité

For your own safety, turn
switch "OFF" and remove
plug from power source outlet be fore maintain-
ing or lubricating your saw.

CLEAR DUST CHUTE/SCOOP

At times, thin cut-offs may fall through the table
insert and down into the dust chute. These may
accumulate and hamper dust collection. Your
SPT99 is designed with a tool-free access Dust
Chute/Scoop for quickly and easily clearing this
space.
1. Loosen dust chute/scoop retainer screw
(Fig. 65).
2. Remove the dust chute/scoop by sliding it
away from the tool and use it to clear any
debris.
3. Reattach dust chute/scoop and secure with
retainer screw.
Tool should not be operated
without securing dust chute/
scoop properly with the retainer screw.
Do not allow sawdust to accumulate inside the
saw. Frequently blow out any dust that may accu-
mulate inside the saw cabinet, motor or blade ele-
vation gears. Clean your cutting tools (i.e. blades)
with a Gum and Pitch Remover.
Periodically clean the guard. Wipe it or blow it
clean with compressed air.
The cord and the tool should be wiped with a dry
clean cloth to prevent deterioration from oil and
grease.
Maintaining Your Table Saw
-49-
Certain cleaning agents and
solvents can damage plastic
parts. Some of these are: gasoline, carbon tetra-
chloride, chlorinated cleaning solvents, ammonia
and household detergents which contain am-
monia. Avoiding use of these and other types of
cleaning agents will minimize the possibility of
damage.
A coat of automobile-type wax applied to the table
will help to keep the surface clean and allow work-
pieces to slide more freely.
If the power cord is worn or cut, or damaged in
any way, have it replaced immediately.
Screw
Dust
Chute/Scoop
FIG. 65