Dado Cutting - skilsaw SPT99 Consignes D'utilisation/De Sécurité

DADO CUTTING

Instructions for operating the saw with Dado Head
sets are contained in the booklet furnished with
these accessories.
ALWAYS USE AN APPROPRIATE SKILSAW
TABLE INSERT AND WASHERS LISTED IN
"RECOMMENDED ACCESSORIES."
ALWAYS PLACE THE BLADE WASHERS IN
THE ORIGINAL POSITIONS WHEN YOU ARE
FINISHED DADO CUTTING.
INSTALLING A DADO SET
A dado set is an accessory system used to make
non-through grooves or lap cuts on work pieces.
These tools are commonly used in furniture and
cabinet building. After work pieces have been
properly dado cut, they can be tightly joined to-
gether. The SPT99 table saw can accommodate
dado cutting up to 13/16" wide in a single pass.
To reduce the risk of injury,
always disconnect plug from
power source before changing blades.
To reduce the risk of injury,
always use the Skilsaw
SPTA70WT-DD 1/2 inch Dado Blade Table
Insert or the Skilsaw SPT00A 13/16 inch Dado
Blade Table Insert (both include dado acces-
sory washer).
Never make dado cuts without this insert. Do not
use dado sets larger than 8" diameter. Never set
dado cutters to any bevel angle other than the
vertical 0° angle. Follow all warnings and instruc-
tions shown here and those that accompany
your dado set. Failure to comply with these warn-
ings may result in serious bodily injuries.
Inner Blade
FIG. 61
Arbor
Inner Blade
Basic Table Saw Operation
Washer
8 inches in diameter. The saw is not designed
to accept larger sized dados.
USING STACKED DADO SETS
NOTE: These instructions apply to most standard
stacked dado sets.
1. Disconnect the plug from the power source.
2. Remove the Barrier Guard Assembly and
Anti-Kickback Device. Lower and lock the
riving knife in its lowest position.
3. Remove the standard table insert plate. Raise
the saw blade to the maximum height.
4. Remove the arbor nut, then the outer washer,
and saw blade. NOTE: For only dado cutting,
leave the inner washer in place. The outer
washer will be replaced with the combination
nut/washer included with either the SPTA70WT-
DD or SPT00A inserts.
5. Installing a dado stack (Fig. 61).
a. Place the desired parts of the dado set onto
the arbor shaft.
b. Place the supplied combination nut/washer
from the Dado Accessory Kit SPTA70WT-DD
or SPT00A onto the outside of the dado stack
and tighten.
6. Placing dado blades and chippers: (Fig. 61).
• For 1/4" wide cuts, place the two outside dado
blades (cutters) on the shaft. The two dado out-
side blades may be different, check for informa-
tion on the blade and the manufacturer's
instructions for proper installation.
Chippers
-46-
To reduce the risk of injury, do
not use dado sets larger than
Combination
Nut/Washer
Outer Blade