Storage, Transporting, And Mounting - skilsaw SPT99 Consignes D'utilisation/De Sécurité

SMART GUARD SYSTEM STORAGE
When not in use, the Main Barrier Guard and An-
ti-Kickback Device can be stored under the table.
Use of all the components of the Smart Guard
System, including Main Barrier Guard, Anti-Kick-
back Device, and riving knife is highly recom-
mended to provide protection against accidents
and injury.
1. Lock the Main Barrier Guard assembly into place
in the same manner as you would attach it to the
riving knife (Fig. 16).
2. Attach the Anti-Kickback Device to the hanging
bracket in the same manner that it attaches to the
riving knife (Fig. 17).
DUST CHUTE ELBOW STORAGE
When not in use, the dust chute elbow can be
stored under the right side of the table (Fig. 17).
RIP FENCE STORAGE
When not in use, the rip fence can be stored
under the left end of the table on the rails.
1. Remove the fence from its in-use position on the
rails.
2. Unlock the rails and extend the rails approxi-
mately 2" to the left of the table. (Fig. 18).
3. Hang the fence upside down under the rails,
using the left side bolt locations as position indi-
cators. Ensure that the flip-over fence, in its
stored position, is facing away from the table saw
frame.
4. Latch the front and rear lock levers
5. Gently slide the rails back toward the center until
the fence is close to the table saw frame, and
then engage the rail locking lever.

Storage, Transporting, and Mounting

FIG. 18
-24-
3
Rip Fence
in its Stored
Position
FIG. 16a
FIG. 17