Getting To Know Your Table Saw - skilsaw SPT99 Consignes D'utilisation/De Sécurité

1. POWER SWITCH
Switch incorporates a hole for use with a
padlock to prevent accidental starting.
2. ELEVATION WHEEL
Elevates or lowers the blade. Also used to tilt
the blade 0 to 45 degrees. The cutting ca-
pacity at 0 degrees is 3.7 inches (94mm).
The cutting capacity at 45 degrees is 2.25
inches (58mm).
3. BLADE BEVEL LOCK HANDLE
Locks the blade to de sired bevel angle.
4. BLADE BEVEL SCALE
Shows the degree to which the blade is tilted.
Total range of the bevel is -1 to 47 degrees.
5. BASE
Supports the table saw. Holes are provided
in base to bolt the saw to a workbench or
stand. Includes integrated carry handle.
6. PUSH STICK & STORAGE
Allows you to rip smaller pieces of stock with
a greater level of safety.
7. RAIL LOCK HANDLE
Allows you to lock the fence at desired dis-
tances.
8. WORK SUPPORT/AUXILIARY FENCE
Provides support for wider workpieces when
FIG. 1
13

Getting To Know Your Table Saw

12
1
2
extending the fence beyond the table.
9. RIP FENCE
Provides an auxiliary support (in the lower
position) and over-the-table support
(upper position). Securely attaches to rails
in 3 positions with locking latches on both
ends.
10. RIP FENCE SCALE
Shows the distance from the blade to the rip
fence through a convenient magnifying view-
ing window. 16.5 inches to left, 30.5 inches
to right.
11. SMART GUARD SYSTEM
Consists of three key elements: Riving Knife
(Splitter), Anti-Kickback Device, and Barrier
Guard Device. All of these are part of a
modular system that requires no tools to as-
semble or disassemble. This Guard System
must always be in place and working prop-
erly for all through sawing cuts.
12. TABLE INSERT
Removable for removing or installing a blade
or other cutting tools.
13. CORD WRAP
Allows you to easily secure the cord so it's
out of the way when transporting or storing.
11
10
4
3
-12-
9
8
7
6
5