skilsaw SPT99 Consignes D'utilisation/De Sécurité page 31

5. Right side, position 2 (further from blade),
see Fig. 31.
NOTE: The right side position 2 for the fence
permits cuts of 6 to 30.5 inches on the right side
of the blade. The bottom scale shows this di-
mension. In this location, the flip-over fence
should be on the left of the main fence when in
the material support position (closest to the
blade).
a. Unlatch the fence clamps and remove the
fence.
b. Loosen the right side position 2 bolts on
the front and back rails so that they can
slide freely, approximately 1/2 to 1 turn.
c. Using the fence alignment holes in the
blade wrench, place the wrench over the
right side position 1 bolt on the front rail
(already fixed in place by step 4 above)
with the second hole roughly aligned with
the right side position 2 bolt.
d. Move the right side position 2 bolt until the
blade wrench slides over the bolt head.
e. Tighten the right side position 2 bolt.
f. Perform steps c through e for the back rail
bolt.
6. Left side, see Fig 31.
NOTE: The left side position for the fence per-
mits cutting of 0 to 16.5 inches on the left side of
the blade. The scale does not show this dimen-
sion. In this location, the flip-over fence should
be on the right of the main fence when in the
material support or auxiliary fence position (clos-
est to the blade).
a. Loosen the left side bolts on the front and
back rails so that they can slide freely, ap-
proximately 1/2 to 1 turn. Move the bolts
so they are approximately 3.5 inches from
the left end of the rails.
b. Place the fence on the left-side bolts but
do not secure the latches on the front or
back rail.
c. Move rails so that the fence touches at
least one tooth on the blade. Lock the rails
in place using the rail lock paddle. If an-
ti-kickback pawls are installed, you will
need to raise the right side in order to
align the fence with the blade.
d. Slide the fence with the front and back
screws towards the blade until the fence
touches the blade teeth at the front and
back of the blade.
Adjustments
e. Tighten the front bolt. Verify that the fence
is still in contact with the front and back
teeth of the blade.
f. Tighten the back bolt. Verify that the fence
is still in contact with the front and back
teeth of the blade.
g. Latch the fence clamps onto the rails and
ensure that the fence is still in contact with
the front and back teeth of the blade.
TO SET THE RIP FENCE POINTER:
1. Lift both guard barriers to their up locked
position.
2. Place the fence on the right side position 1
bolts and lock the fence clamps on the front
and back.
3. Raise rail lock paddle and move the fence
until it is alongside the saw blade by lifting
the right side pawl above the fence. Lock the
rails in place.
4. Loosen pointer adjustment screw, adjust
pointer to "0" mark on lower scale, then
re-tighten the screw.
FIG. 30
Scale
FIG. 31
Left Side
-31-
Rip Fence Point
Pointer Adjustment Screws
Right Side 1 Right Side 2