Basic Table Saw Operation; Safety Power Switch - skilsaw SPT99 Consignes D'utilisation/De Sécurité

Table des Matières

Les langues disponibles

Adjustment of Left-side Material Support on

Tool Stand

1. Loosen the nuts on the carriage bolts and

remove the locking bolts on the front and

back sides of the left-side material support.

2. Remove the fence from the table and place

the top side of the fence flush against the ta-

ble, overhanging the left-side material sup-

port. The plastic end bracket should sit in the

miter slot so that the aluminum fence con-

tacts the table top.

3. Move the fence as close to the front edge of

the left-side material support as possible.

4. Raise the front of the support until it is in con-

tact with the fence. Note, a rubber mallet

may be required to move the material sup-

port. During adjustment, the material support

should be flush to 0.2 inches (5mm) below

the table surface.

5. Install the locking bolt and tighten the carriage

nut on the front of the support.

6. Move the fence as close to the back edge of

the left-side material support as possible.

SAFETY POWER SWITCH

NOTE: This table saw has a safety feature that

helps pre vent accidental starting. When power is

cut to the saw, the tool will switch to the off mode.

Once power is restored, the tool will need to be

turned on again.

To turn saw on: Press the green button

(Fig. 39).

To turn saw off: Press the red paddle (which

depresses the red off switch underneath)

(Fig. 39).

To prevent unauthorized use: the switch can ac-

commodate a padlock with a long 3/16" diameter

shackle (not included) (Fig. 40).

Adjustments