Unpacking And Checking Contents; Tools Needed For Assembly And Adjustment - skilsaw SPT99 Consignes D'utilisation/De Sécurité

STAND ASSEMBLY HARDWARE (PACKAGED IN ONE BAG)
Itm. Qty.
A 2 ea
B 4 ea.
C 2 ea
D 4 ea

Tools Needed for Assembly and Adjustment

Disconnect the plug from the power source before performing any assembly,
adjustment or repair to avoid possible injury.
Phillips & Flat Head
Screwdriver
Blade Wrench
(supplied)
1. Position square and
draw a light line
3/4" board with
straight top edge

Unpacking and Checking Contents

Figure
Adjustable Wrench or
1/2 inch Wrench and
11/16 inch Wrench
5 MM Hex "L" Wrench
COMBINATION SQUARE MUST BE TRUE
drawn line
Part Description
5/16 in. x 2 in. carriage bolt (for handle bar) with
washer and lock nut
5/16 in. x 3.5 in. carriage bolt (for h-shaped frame)
with black plastic spacer, washer and lock nut
11/16 in (7mm) washer and lock nut for wheels
5/16 in. x 3.5 in. carriage bolt (to mount tool to
stand) and lock nut
(supplied)
2. Flip square
(shown in dotted position)
3. Check edge of flipped
square against the drawn line.
There should be no gap or
overlap at the bottom end.
no gap or overlap
-16-
Combination Square