Attaching The Smart Guard System - skilsaw SPT99 Consignes D'utilisation/De Sécurité

ATTACHING THE SMART GUARD SYSTEM

To prevent personal injury,
always dis con nect the plug
from the power source before attaching or
removing the Smart Guard System.
POSITIONING THE RIVING KNIFE
1. Remove the table insert using finger hole.
2. Raise the blade as high as it will go and set it
perpendicular to table (0° on bevel scale)
(Fig. 5).
3. Rotate the riving knife release lever clockwise,
so that it points upward (Fig. 5).
4. Pull the riving knife toward the release lever to
disengage it from the pins.
5. Slide the riving knife up to its highest position,
so that it is directly over the center of the blade
(Fig. 6).
6. Align the holes in riving knife with the pins and
lock the release lever by rotating it counter-
clockwise. Push/pull on the riving knife to verify
that it is locked in place (Fig. 6).
7. Replace the table insert (Fig. 7).
ATTACHING THE GUARD ASSEMBLY
8. With one hand, hold the front of the barrier
guard assembly by the metal "fork." With the
other hand, hold the guard release lever up
(Fig. 7).
9. Lower the rear of guard assembly and slip the
cross bar into the rear notch on top of the riv-
ing knife (Fig. 7).
Assembly
Guard Release
Lever
Riving Knife
-20-
FIG. 5
Riving Knife
Release Lever
FIG. 6
Pins
FIG. 7
Rear Notch
Cross Bar