Table des Matières
Publicité
Using the seam guide lines
The seam guides on the needle plate help you to
measure seam allowances.
w
NOTE:
The number indicates the distance from the center
needle position.
q
Turning square corners
To turn a square corner 5/8" (1.6 cm) from the fabric
edge:
When the fabric edge facing you lines up with the
cornering guide as illustrated, stop stitching and
lower the needle by turning the handwheel towards you.
Raise the presser foot and turn the fabric to line
the edge with the 5/8˝ (1.6 cm) seam guide.
Lower the presser foot and begin stitching in the new
direction.
q
Sewing from the edge of thick fabric
The black button on the zigzag foot locks the foot in
the horizontal position.
This is helpful when starting sewing from the extreme
edge of thick fabrics or sewing across a hem.
Lower the needle into the fabric at the point where you
q
wish to start sewing.
Lower the foot while pushing in the black button.
The foot will be locked in the horizontal position to
avoid slipping.
The foot will be unlocked after sewing a few stitches.
q
40
q Guide lines
w Center needle position
Number
15
20
Distance
1.5
2.0
(cm)
Distance
(inch)
q Cornering guides
q Black button
4/8
5/8
6/8
1.9
1.3
1.6
1/2
5/8
3/4
Publicité
Table des Matières
