IKEA GRUNDLAGGA Mode D'emploi page 37

EN
Setting Self Clean
To set self clean:
1. Be sure the oven is empty and all oven racks are
removed. Remove all items from the oven. Be
sure oven door is completely closed.
2. Press Self Clean and the default 3 hour clean
time will appear in the display. You may accept
the default 3 hour clean time or choose a dif-
ferent clean time by pressing the Self Clean key
to toggle between 2, 3, and 4 hours clean time.
Once you have the desired clean time selected
proceed to Step 3.
3. Press START to activate self clean.
When the oven is set to run a self-clean cycle, the
motor door lock will begin locking the oven door.
Do not open the oven door while the lock motor is
running or when any locking indicators or displays
are showing. The oven door is completely locked in
about 15 seconds. Once the oven door has locked,
CLEAN will appear in the display indicating self
clean has started.
Do not force the oven door open when self-clean is
active. This can damage the automatic door-locking
system. Use caution when opening the door after
self-clean cycle is complete; the oven may still be
very hot.
When self clean is fi nished:
1. CLEAN message will turn off, and Hot will appear
in display window.
2. Once the oven has cooled down (about 1 hour)
and Hot is no longer displayed, the oven door
may be opened.
3. When the oven interior has completely cooled,
wipe away any residue or powdered ash with a
damp cloth or paper towel.
CAUTION
To avoid possible burns, use care when opening
the oven door after the self-cleaning cycle. Stand
to the side of the oven when opening the door to
allow hot steam and air to escape.
Setting Delay Start Self Clean
To start a delay self clean with default clean time of
3 hours and a start time of 9:00 o'clock:
1. Be sure the clock is set with the correct time
of day, the oven is empty, and all oven racks
are removed. Be sure oven door is completely
closed.
2. Press Delay Start.
3. Using numeric keypad, enter 9 0 0.
4. Press START to accept
5. Press Self Clean.
6. Press START.
To stop or interrupt a self clean cycle (once it
has been activated):
1. Press OFF.
2. Once the oven has cooled down for about 1 hour
and the door locked light has turned off, the
oven door can be opened.
3. Restart the self clean cycle once all conditions
have been corrected.
NOTE
If your clock is set with the (default) 12 hr display
mode, the delay start for a self clean can only be
programmed to start up to 11 hours and 59 min-
utes after the time showing in the display (be sure
to set the clock to current time before program-
ming a Delay Start). To set a Delay Start self clean
to begin 12 or more hours (maximum is 23 hours
and 59 minutes) after the time of setting, be sure
to fi rst set the control in the 24 Hr display mode.
If self clean was active and then interrupted by
a power failure or cancelled before the oven was
thoroughly cleaned, it may be necessary to run
another self clean cycle.
If the oven temperature was high enough when
self clean was interrupted the oven control may
not allow another self clean cycle to be set for up
to 4 hours.
OVEN CONTROLS
37