IKEA GRUNDLAGGA Mode D'emploi page 20

Masquer les pouces Voir aussi pour GRUNDLAGGA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OVEN CONTROLS
Setting the Clock
When the appliance is fi rst plugged in or when the
power supply to the appliance is interrupted, the
display will fl ash 12:00. It is recommended to always
set the clock for the correct time of day before using
the appliance.
To Set Clock to 1:30:
1. Press Set Clock.
2. Enter 1 3 0 using numeric keys.
3. Press START.
NOTE
The clock cannot be changed when a Self Clean,
Delay Start, or cooking feature is active.
Temperature display
(Fahrenheit/Celsius)
The oven control is set to operate in Fahrenheit (°F)
at the factory. The oven may be programmed for any
temperature from 170°F to 550°F (77°C to 288°C).
To change the temperature to Celsius (°C) or
from °C to °F:
1. Press and hold Broil key for 6 seconds.
2. When F(orC) appears, press Self Clean to
toggle between Fahrenheit and Celsius
temperature display modes.
3. Press START to accept the choice.
NOTE
The oven temperature display cannot be changed
during the cooking process or if a delay start has
been set or self clean is active
20
Changing between continuous bake or
12-hour energy saving feature
The oven control has a built-in 12-hour energy sav-
ing feature that will shut off the oven if the oven is
left on for more than 12 hours.
The oven control can be programmed to override
this feature for continuous baking.
To change between continuous bake or 12 hour
energy saving feature:
1. Press and hold Timer On-Off for 6 seconds
2. Press Self Clean to toggle between 12 Hour OFF
or Stay On feature.
3. Press START to accept choice
IMPORTANT
Changing to continuous bake or 12 hour mode
does not change how the cooktop controls
.
operate
Setting a silent control panel
Silent mode allows the oven control to operate with
no audible tones. The control may be programmed
for silent operation and later reset to operate with
all the normal audible tones.
To set for silent or audible mode:
1. Press and hold Delay Start key for 6 seconds.
2. Press the Self Clean key to toggle between
bEEP On or bEEP OFF.
3. Press START to accept the choice.
EN

Publicité

Chapitres

Table des Matières
loading

Table des Matières