Section 3. Care And Maintenance; Cleaning The Machine - Alfa 3000 Manuel D'instructions

q
w

SECTION 3. CARE AND MAINTENANCE

Cleaning the Machine

Turn the power switch OFF and unplug the machine
when performing any cleaning or maintenance.
Raise the needle to the highest position to avoid
accidental contact with the needle before cleaning.
q
Remove the extension table and open the bed cover.
Remove any lint or dust accumulated inside the cover.
Brush away any dust on the needle unit and presser
foot.
Close the bed cover.
NOTE:
Clean inside of the bed cover after every use.
q
Remove the cap and setscrew with a screwdriver.
Remove the face plate.
Brush away any lint or dust accumulated around needle
bar area.
You may also use a vacuum cleaner if there is a large
amount of lint, but always finish with the brush.
Attach the face plate with the setscrew.
Attach the cap to the face plate.
NOTE:
Clean inside of the face plate after every project.
Clean the outside of the machine with a soft cloth. Do
not use chemical solvent.
Store the machine in cool and dry place.
Do not store the machine in an area of high humidity,
near a radiator or in direct sunlight.
22
WARNING–
To reduce the risk of injury:
q Bed cover
q Cap
w Setscrew