Technical Data - SOMFY Sonesse 30 Zigbee Li-ion Notice

Sonesse 30 WF Zigbee Li-Ion
6) Insert and slide the new battery into the drive tube, leaving the battery connector accessible from
the outside of the tube.
7) Connect the new battery.
8) Insert the motor head using the keying notches on the drive
tube taking care not to cut off the wires.
9) Screw the motor head using the two T6 torx screws or
cruciform screws to the drive tube.
10) Restart the installation in chapter 2.1.3. Drive/tube assembly.

4. TECHNICAL DATA

Power supply
Radio frequency
Frequency bands and maximum power used
Torque
Electrical insulation
Operating temperature
Protection rating
Charging temperature
͉
͉
For additional information on the technical data for this drive contact your Somfy representative.
Please separate storage cells and batteries from other types of waste and recycle them via the
local collection facility.
We care about our environment. Do not dispose of the appliance with usual household waste.
Give it to an approved collection point for recycling.
SOMFY ACTIVITES SA, F-74300 CLUSES as manufacturer hereby declares that the drive
covered by these instructions and used as intended according to these instructions is in
compliance with the essential requirements of the applicable European Directives and in
particular of the Machinery Directive 2006/42/EC, and the Radio Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at www.somfy.com/ce.
Antoine Crézé, Approval manager, acting on behalf of Activity director, Cluses, 07/2018.
Copyright 2017 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
6
7
8
9
10
2.1.3. Drive/tube assembly.
12 Vdc SELV
2.4 GHz
2.4 GHz - 2.4835 GHz e.r.p < 10mW
2 Nm
III
0°C à + 60°C
IP 20 (For indoor use only)
0 / +45°C
EN
7