Preparation; Opening Out The Handle (Illustration A1 + C1 + E1 ) - Sabo 54-PRO A Livret D'entretien

• If the tank has to be emptied, this should be done in the open, and with a
cold engine. Take care to ensure that no fuel is spilt.
For reasons of warranty and safety, only genuine spare parts may be used.
Non-equivalent spare parts can damage the machine and are a safety hazard.
7 DESCRIPTION OF COMPONENTS
54-PRO A, 54-PRO VARIO
1 Safety control bar for engine stop
2 Knob for Vario actuation, only for model 54-PRO VARIO
3 Drive control bar
4 Tank cap
5 Engine cover
6 Air filter
7 Cutting height setting
8 Carrying handle
9 Spark plug
10 Starter cable handle
11 Oil refill neck with dipstick
12 Exhaust protection grid
13 Belt drive covers
14 Ejector flap
15 Grass collector
54-PRO VARIO PLUS
1 Safety control bar for engine stop
2 Knob for Vario actuation
3 Drive control bar
4 Tank cap with ventilation valve
5 Engine cover
6 Air filter
7 Fuel tap
8 Oil filter
9 Cutting height setting
10 Carrying handle
11 Spark plug
12 Exhaust protection grid
13 Belt drive covers
14 Ejector flap
15 Grass collector
16 Oil refill neck with dipstick
17 Starter cable handle
All models

8 PREPARATION

The following unit parts are included in the mower assembly package:
• Mower with pre-assembled guide bar
• Grass catch, collecting bag frame
• Tool bag containing the following:
– Operating manual with Declaration of Conformity
– Guarantee conditions
– Spark plug spanner
– Diverse attachment parts.
Should a part be missing, please contact your professional dealership.
NOTE
Always remove the spark plug connector before fitting the bar and the starter
cable holder. Following assembly, at the latest before starting the engine, push
the spark plug connector back in place.

Opening out the handle (Illustration A1 + C1 + E1 )

Pull the guide bar which is collapsed in a Z-shape upwards into place in the following
sequence:
– First swivel the bottom part of the guide bar A1 to the rear until the bore hole on
the end of the bar is aligned with one of the two bore holes in the bar connection.
– Insert the two hexagon bolts M8x30 (1) (from the tool bag) with fitted safety edge
washers (2) from outside through the handlebar and bar connection and tighten
up C1 .
6