Husqvarna TE 250 2009 Livret D'utilisation Et D'entretien page 170

MUM2-250_310_450_510_2009_GB
HEADLAMP BULBS REPLACEMENT
(TE-SMR)
To gain access to the healamp bulbs, proceede as follows:
- remove the upper fastening screw of the the headlamp carrier to
the instrument panuel support (A);
- push forward the headlamp carrier (B) and pull it towards the
high (C) in order to uncouple from the two lower supports.
- remove the headlamp carrier;
C
B
78
21-05-2008 9:50 Pagina 78
- remove the two filaments bulb connector; (2) and the boot
(3);
- release the bulb holding spring (4) and then the bulb itself.
To replace the parking light bulb (5) extract it from the inside
cover.
After replacement, reverse operations for reassembly.
A
5
2
REAR TAIL LIGHT BULB REPLACEMENT
(TE- SMR)
Remove the two fastening screws (1) in the inner side of the rear
fender and the lens (2).
4
3