Husqvarna TE 250 2009 Livret D'utilisation Et D'entretien page 125

MUM1-250_310_450_510_2009_GB
ADJUSTING THE CARBURETTOR (TC-TXC)
Adjust the carburettor with warm engine and with the throttle in
closed position.
Work as follows:
- Turn slow running adjusting screw (1) on the left side of the
bike, , until the engine is turning over at fairly high rpm (turn
the screw clockwise to increase the rpm, and anticlockwise to
descrease the rpm).
- Turn adjusting screw (2) clockwise until the fully closed posi-
tion is reached then turn back 1,5 turns (TXC 250) 2,0 turns
(450-510)
- progressively loosen adjusting screw (1) to obtain the slow
running required.
ADJUSTING THE IDLE (TC-TXC)
Adjust the carburetor with warm engine and with the throttle
control in closed position. Proceed as follows:
- Turn slow running adjusting screw (1) on the left side of the
bike, near the fuel cock (turn the screw clockwise to increase
the rpm, and anticlockwise to descrease the rpm).
21-05-2008 9:29 Pagina 33
ADJUSTING THE IDLE (TE-SMR)
Adjust the carburetor with warm engine and with the throttle
control in closed position. Proceed as follows:
- turn the idle speed adjustment screw (3) on the throttle body,
located on the right side of the vehicle, until the idle speed of
1600 RPM is reached (turn clockwise to increase the speed
and anti-clockwise to reduce the speed).
3
33