Publicité
MULTI-FUNCTION DISPLAY
Returning to BASIC MODE from RACE
MODE
NOTE:
It is possible to return to BASIC MODE with
timer measurement at a stop.
1. Check that the timer is not in operation. If
the timer is in operation, stop the timer by
pushing the "SLCT1" button and "SLCT2"
button at the same time.
2. Push the "SLCT1" button and "SLCT2" but-
ton for 2 seconds or more at the same time
to change over to BASIC MODE.
RACE MODE
Putting measurement on standby
NOTE:
Starting measurement consists of the following
two starts, either of which can be selected.
• Manual start
Starting measurement by the rider himself
operating the button. (A long push on "SLCT2"
button will put measurement on standby.)
• Auto start
Starting timer measurement automatically on
detection of the movement of the machine. (A
long push on "SLCT1" button will put measure-
ment on standby.)
Manual start
NOTE:
Initial setting at changeover to RACE MODE
will remain for manual start.
1. Check that changeover to RACE MODE
has been made. (Refer to "Changeover
from BASIC MODE to RACE MODE".)
NOTE:
When the machine is made ready for a run by
manual start,
1 - 17
GEN
INFO
and
will start flashing.
Publicité
Chapitres
