Ottobock 1E95 Challenger Instructions D'utilisation page 11

2 Intended use
2.1 Indications for use
The product is to be used solely for lower limb prosthetic fittings.
The product is intended to be used in fitness prostheses.
2.2 Area of application
• The maximum approved body weight is specified in the technical data (see Page 16).
2.3 Environmental conditions
Allowable environmental conditions
Temperature range for use: -10 °C to +60 °C
Storage and transport conditions: -10 °C to +60 °C, relative humidity: no restrictions
Moisture: fresh water, salt water, chlorinated water, sweat, urine
Dust, sand, highly hygroscopic particles (e.g. talcum)
Clean the product after it has come into contact with moisture/sand/dirt.
Unallowable environmental conditions
Acids
2.4 Service Life
Prosthetic foot
As part of a fitness prosthesis, an exact service life cannot be determined for the product since
strain varies widely depending on the fitness activity and intensity of use.
Heel wedge, forefoot pad
The product is a wear part, which means it is subject to normal wear and tear.
3 Safety
3.1 Explanation of warning symbols
Warning regarding possible risks of accident or injury.
CAUTION
NOTICE Warning regarding possible technical damage.
3.2 General safety instructions
CAUTION
Use under extreme loads
Risk of injury due to extreme loads from extreme activity
While the product was designed for active fitness activities, extreme loads may damage the
►
product.
► Inspect the product before and after each activity for damage.
► If damage is apparent or in case of doubt, do not continue using the product.
CAUTION
Use under unallowable environmental conditions
Risk of injury due to damage to the product
► Do not expose the product to unallowable environmental conditions.
► If the product has been exposed to unallowable environmental conditions, check it for dam­
age.
► If damage is apparent or in case of doubt, do not continue using the product.
11