Déclaration Du Fabricant - Inficon Sensistor ILS500 F Mode D'emploi

15 Déclaration du fabricant
DECLARATION BY THE MANUFACTURER
Manufacturer
INFICON AB
Westmansgatan 49
SE-582 16 Linköping
Sweden
Hereby declares that
Sensistor ILS500, Leak Detection System, ...
Sensistor ILS500 HP, Leak Detection System, high pressure model...
Sensistor ILS500 F, Leak Detection Filler, ...
Sensistor ILS500 FHP, Leak Detection Filler, high pressure model...
Type no for construction identification: ILS.210.306)
(
- is intended to be incorporated into machinery or to be assembled with other machinery to
constitute machinery covered by Directive
and furthermore declares that is not allowed to put the equipment into service until the
machinery into which it is to be incorporated or of which it is to be a component has been found
and declared to be in conformity with the provisions of Directive
implementing legislation, i.e. as a whole, including the equipment referred to in this declaration.
The delivered equipment (Sensistor ILS500) is intended to be connected to an emergency stop
circuit. The enclosed plug with cable jumper is only intended for testing the equipment when not
incorporated into machinery covered by Directive
not be used when such machinery is put into service.
For INFICON AB, November 28, 2013
_____________________________________
Fredrik Enquist, R&D Manager
INFICON AB
Box 76, SE-581 02 Linköping, Sweden
Phone: +46 (0) 13 35 59 00 Fax: +46 (0) 13 35 59 01
www.inficon.com
(Directive 2006/42/EC, Art. 4.2 and Annex II, sub B)
PROHIBIT TO PUT EQUIPMENT INTO SERVICE
E-mail: reach.sweden@inficon.com
2006/42/EC
, as amended;
2006/42/EC
2006/42/EC
. The jumper plug must therefore
and with national
Déclaration du fabricant 101