Bosch EV400 Serie Guide D'installation/Mode D'emploi page 17

3. Remove the template from the wall and install two (2) 3/16" (5-mm) tapered-head masonry screws. Drive these
screws leaving a 1/2" space from the top of the screw head to the wall surface. This will provide the proper spacing
required for the mounting slots on the back of the unit.
4. Align the EV400 to the mounting screws and gently slide the unit down to secure it within the rear mounting slots.
Plug the EV400 into the appropriate, existing power receptacle.
NOTE: The EV400 has 4 radiased corner standoffs
that must be touching the wall-mounting surface to
assure stability. Tighten the 2 mounting screws as
needed to accomplish this.
Installation and Operating Instructions | Bosch™ EV400 Series Charging Station | 17 | en
REV E | 02.19.2019