Amperage And Breaker Parameters; Mounting Instructions; Package Contents; Tools For Package Contents - Bosch EV400 Serie Guide D'installation/Mode D'emploi

en | 12 | Installation and Operating Instructions | Bosch™ EV400 Series Charging Station
6 Amperage and Breaker
Parameters
The EV400 has been factory set at an output current
setting of 4 for Table 1 and 5 for Tables 2 and 3. For all
other amperages, changes to output amperage may be
made by a qualified electrician as follows:
1. Unplug the EV400 from the wall outlet and turn power
off to the outlet at the breaker panel.
2. Remove the adhesive overlay from the molded well on
the back of the EV400.
3. Using a small flat-blade screwdriver, set the current-ad-
justment selector to the applicable output current-limiting
setting indicated in the appropriate table below.
NOTE:
1. North American current setting is 30A (setting 4). This
setting is NOT to be exceeded. Settings of 30A or less
(settings 1-4) only are permitted on North American
models.
2. Adhesive overlay must be replaced securely to the
molded well to preserve the EV400's environmental ratings
and warranty.
REV E | 02.19.2019
7

Mounting Instructions

7.1 Package Contents

} (1)EV400 Series Charging Station
} (1)EV400 Series Charging Station hardware kit:
(2) #8 x 1-1/4" Pan-head Screws (for EV400 stud-mount
applications)
(2) 3/16" x 1-1/4" (5mm) Tapered-head Masonry
Screws (for EV400 masonry-mount applications)
} (1) EV400 Cord-set Hanger
} EV400 Cord-set Hanger hardware kit:
(2) Cord-set Hanger Spacers
(2) #10 x 2-1/2" Philips Black-oxide Screws (for Cord-
set Hanger stud-mount applications)
(2) 3/16"(5mm) x 2-1/4" Flat-head Philips Masonry
Screws (for Cord-set Hanger masonry-mount
applications)
7.2 Tools Required for Package Contents
} Level
} 1/8" drill-bit (for EV400 and Cordset-hanger stud-mount
applications)
} 5/32" masonry drill-bit (for EV400 and Cordset-hanger
masonry-mount applications)
} Power drill
} Pencil
} Screw driver – Phillips#2
} Stud finder
} Tape measure
} Adhesive tape
7.3 Optional Kit #1: Metal Mounting
Bracket
} 1 Metal wall bracket
} (3) #10 x 2-1/2" Black-oxide Metal Wall Bracket
Mounting Screws (for stud-mount applications)
} (3) 3/16" x 1-1/4" Masonry Screws (for Metal Wall
Bracket Mounting (for masonry-mount applications)
} (8) #8 x 1/2" Pan-head Screws (for mounting 2-Metal
EV400 Brackets to EV400 Unit)
7.4 Tools Required for Optional Kit #1
} Level
} Power drill
} Pencil
} Screw driver – Phillips#2
} Stud finder
} Tape measure
} 1/8" drill-bit (for EV400 and Cordset-hanger stud-mount
applications)
} 5/32" masonry drill-bit (for EV400 masonry-mount
applications)