Bosch EV400 Serie Guide D'installation/Mode D'emploi page 14

en | 14 | Installation and Operating Instructions | Bosch™ EV400 Series Charging Station
3. Using a 1/8" (3-mm) drill bit, drill 2-holes at the target-points on the template. These two points are vertically located
with reference to each other (they are also 4.9 in [125-mm] apart).
4. Install two (2) #8 pan-head screws to the screw holes; drive these screws leaving a 0.40" space from the top of the
screw head to the wall surface. This will provide the proper spacing required for the mounting slots on the back of the
unit.
REV E | 02.19.2019