Operation - StarLab RM Multi-1 Mode D'emploi

4

Operation

Recommendation during operation
› Arrange the tubes symmetrically in relation to the rotation axis when loading.
› Connect the external power supply unit to the electric circuit.
› Place samples on the platform; long tubes should only be inserted about half of their length.
› Set the appropriate program and operation time (see Program Setting section).
› Press the Run Stop key (Fig.1/6) to start the program.
› The platform motion will begin and the corresponding indication (, Fig.1/4 and the chan-
ging time values) will be shown on the display.
› If the operation time is not set and the timer indicator (Fig.1/2) shows 0:00, pressing the Run
Stop key will cause continuous operation of the rotator until the Run Stop key is pressed again.
› If the operation time is set the platform movement will stop after the set time has expired
(flashing indication  Fig. 1/4 will be shown on the display) and will start giving a sound
signal at the end of operation (press the Run Stop key to stop the signal).
› Press the Run Stop key to repeat the set program.
› The rotator can be stopped at any time during operation before the set time expires by
pressing the Run Stop key. In this case, the platform motion stops when the platform
achieves horizontal position. Pressing the Run Stop key again will start the program from
the beginning (countdown timer will be restarted).
› Disconnect the external power supply unit from electric circuit to turn off the unit.
Note: A step motor is used in this unit. Stopping the platform briefly by hand is allowed
and does not damage the mechanical parts of the device. If the platform is stopped by
hand during operation, the program does not stop and the platform motion is auto-
matically resumed after the platform is released.
8
· Rotator Mixer RM Multi-1 · Manual