Program Setting - StarLab RM Multi-1 Mode D'emploi

5

Program setting

Note: When setting program parameters, please bear in mind that the unit may not
be able to operate properly in reciprocal and vibration modes with maximum load. The
recommended load is indicated in Table 1 on page 11.
› Press the Select key (Fig.1/1) to choose the parameter to change (the active parameter will
flash).
› Use the  and  keys (Fig.1/5) to set the necessary value.
(Press and hold the key for 2 seconds for the numerical values to change quickly.)
› Saving the program does not require additional steps: the microprocessor automatically saves
the last parameter change as the working program.
› The countdown timer is used to control the operation time. The timer can be set for a period
of 1 min to 24 hours.
› Press and hold the Select key for 4 seconds to change the reciprocal
motion mode (tube position – either vertical or horizontal).
When the tube icon (Fig. 1/3) is in vertical position, reciprocal rotation starts
with tubes in vertical position (platform in horizontal position).
When the tube icon is in horizontal position, reciprocal rotation starts with
tubes in horizontal position (platform in vertical position).
› The examples below show separate motion types and their available combi-
nations in cycles. The data to the right shows the possible parameter values
for each type.
Orbital Rotation:
› Set the speed of Orbital rotation
(1-100 rpm) and the time. Set the time for Reciprocal
motion to 0 (OFF).
› Orbital + Reciprocal Rotation:
(1-100 rpm) and time (1-250 seconds) of Orbital rotation.
Set the turning angle (1-90º) and time (1-250 seconds) for
Reciprocal motion. Switch off the Vibro motion by setting
the time of Vibro motion to 0 (OFF).
Orbital + Reciprocal + Vibro:
›
and time (1-250 seconds) of Orbital rotation. Set the angle
(1-90º) and time (1-second) for Reciprocal motion. Set the
turning angle (0-5º) and time (1-second) for Vibro motion.
Note that if the set time of Reciprocal motion is shorter or
equal to the set time of Vibro motion, then the Reciprocal
motion will be omitted (Orbital + Vibro).
Set the speed
Set the speed (1-100 rpm)
Rotator Mixer RM Multi-1 · Manual ·
9