StarLab RM Multi-1 Mode D'emploi page 10

› Orbital + Reciprocal + Pause:
(1-100 rpm) and time (1-250 seconds) of Orbital
rotation. Set the turning angle (1-90º) and time
(1-250 seconds) for Reciprocal motion. Set the angle of
Vibro motion mode to zero. Set the time for Vibro/Pause
mode (1 second), which is the time of Pause duration.
Note that if the set time of Reciprocal motion is shorter
or equal to the set time of Vibro/Pause mode, the Reciprocal motion mode will be omitted
(Orbital + Pause).
› Reciprocal Rotation:
rotation to zero (OFF). Set the turning angle (1-90º) and time (1-250 seconds) of Reciprocal
motion. Set the time for Vibro motion to zero (OFF).
Reciprocal + Pause:
›
to zero (OFF). Set the angle (1-90º) and time (1-250 seconds) of Reciprocal motion. Set the time
for Vibro motion type (1 second), which is the time of pause duration. Set the angle of Vibro
type motion to zero.
Vibro + Reciprocal Rotation:
›
Orbital rotation to zero (OFF). Set the angle (1-90º) and time (1-250 seconds) of Reciprocal
motion. Set the angle (0-5º) and time (1-5 seconds) of Vibro type motion.
Caution! To avoid platform drift during Vibro motion, do not load the platform over the
weight specified in the Table 1, Specifications. When working with the unit in Vibro
motion mode for long periods and using the platform with rubber clamps, choose tubes
smaller than 7 cm from cap to bottom.
10
· Rotator Mixer RM Multi-1 · Manual
Set the speed
Set the speed (1-100 rpm) for Orbital rotation. Set time for Orbital
Set the speed (1-100 rpm) of Orbital rotation. Set time of Orbital rotation
Set the speed (1-100 rpm) of Orbital rotation. Set the time of