Electrical Connection; Positioning Of The Appliance On The Bracket; Drainage - Olimpia splendid UNICO EASY S1 Mode D'emploi

2.6 - ELECTRICAL CONNECTION

The appliance is fitted with a power cable with plug.
Before connecting the air conditioner ensure that:
• The voltage and power frequency values match those specified on the
appliance plate data.
• The power line is equipped with an effective earth connection and is
correctly sized for maximum power consumption of the air conditioner.
• The appliance's power network must be equipped with a suitable
omnipolar disconnection device compliant with national installation
regulations.
• The appliance is powered solely through a socket compatible with the plug provided.
CAUTION
Any replacement of the power cable must be carried out solely by Olimpia Splen-
did technical support or by similarly qualified personnel.

2.7 - POSITIONING OF THE APPLIANCE ON THE bRACKET

a. Before fastening the machine to the fixing bracket, apply the three supplied seals to the backrest (fig.
6).
b. Check that the wall fixing bracket (1) has been positioned correctly and fasten the air conditioner. Slightly
lift it holding by the sides of the lower base and position it against the wall.
Check that the air conditioner has hooked to the bracket (1) and put it on the floor (fig. 12).
Pay the utmost attention since the bracket (1) must not bear the weight of the air conditioner, it only
has to prevent possible accidental movements which may hinder its correct aligning with the holes
on the wall. Adjust the height of the air conditioner using the adjustable feet (30) it is equipped with
if necessary.
c.
at the end of the work, carefully check that no cracks remained behind the backrest of the appliance
(the insulating seal must adhere to the wall well), especially in the area of the air inlet and outlet ducts.
d. once the air conditioner has been successfully installed, place the two aesthetic covers (10) snapping
them on the lower feet (30) (fig.13).

2.8 - DRAINAGE

For the correct use of the appliance, work as follows (figure 32):
a. remove the cap (26).
b. insert the supplied pipe (9) in the connector.
Make sure the end of the discharge pipe (9) is positioned
on a drain well or in a container.
Make sure the pipe (9) is not clogged.
32
UNICO EASY S1
26
9
EN - 13