Setting Manufacturer Codes - Yamaha DSP-Z9 Mode D'emploi

Setting manufacturer codes

You can control other components by setting the
appropriate manufacturer codes. Codes can be set for each
input area.
The following table shows the input area (default
component), component category (Library) and
manufacturer code for each area.
Input area Component category
(Library)
V-AUX
TUNER TUNER
PHONO
CABLE CABLE
SAT
MD/TAPE
CD-R CD-R
CD
DTV/LD
VCR 1
VCR 2
DVR DVD
DVD DVD
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA manufacturer code is initially set as listed above.
In this case, try to set another YAMAHA manufacturer code(s).
1
Press an input selector button to select the
source component you want to set up.
V-AUX TUNER PHONO
CABLE SAT MD/TAPE CD-R CD
DTV/LD VCR 1 VCR 2 DVR DVD
2
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object.
"SETUP" and the selected component name appear
alternately in the display window.
LEARN
Be sure to press down LEARN for at least 3 seconds,
otherwise the learning process will start.
y
Complete each of the following steps within 30 seconds.
Otherwise, the learning mode is automatically canceled. In
this case, press LEARN again.
Manufacturer
code
VCR –
YAMAHA 1
TV –
–
SAT –
MD YAMAHA 1
YAMAHA
CD YAMAHA 1
TV –
VCR –
VCR –
–
YAMAHA 1
If you want to change a library (component
category), press l / h to set a different
component type.
Library choices: L:DVD, L:LD, L:CD, L:CDR,
L:MD, L:TAP, L:TUN, L:AMP*, L:TV, L:CAB,
L:DBS, L:SAT, L:VCR
* The amplifier Library (L:AMP) code is preset to "YPC"
to operate this unit. However, you can switch between the
following four codes if necessary.
YPC
To operate this unit (without ZONE 2 features).
ZONE
To operate this unit (with ZONE 2 features).
DSP
To operate YAMAHA DSP amplifiers that cannot
be operated with the YPC code.
NO
To operate the amplifiers of other manufacturers
using this unit's remote control.
3
Press k/n to select the name of your
component's manufacturer.
You will find the names of most worldwide audio-
video manufacturers in alphabetical order in the
display window.
ENTER
4
Press one of the buttons shaded below to
see if you can control your component. If you
can, the manufacturer code you set is
correct.
SOURCE
INPUT MODE
DISPLAY
SELECT
SEARCH
POWER REC
y
• If more than one code is listed for the manufacturer of
your component, try each of them until you find the
correct one.
• If you want to continue setting up a code for another
component, press ENTER and repeat steps 1, 3 and 4.
REMOTE CONTROL FEATURES
MULTI CH IN
PURE DIRECT
TITLE
ENTER
TOP EXIT
MENU SOUND
– +
CHAPTER
STOP PAUSE PLAY
81