Setting The Manufacturer Code In The Remote Control - Yamaha DSP-AX1 Mode D'emploi

Setting the Manufacturer Code in the Remote Control

You can control other components by setting a manufacturer code. A code can be set up in each component controol area except for the
OPTN area. The Yamaha code is factory preset for DVD, LD, CD, MD, TUNER, and TAPE (Yamaha for LD, and Yamaha1 for others).
There is no factory preset code on VCR1/2/3, D-TV, CBSAT, V-AUX, and PHONO.
SYSTEM
POWER STANDBY V-AUX TAPE
D-TV CBL/SAT TUNER MD
VCR 1 VCR 2 VCR 3 LD
LEARN
%
TITLE
ENTER
SOURCE
%
%
DISPLAY MENU
SELECT SEARCH – CHAPTER
%
! ! $
POWER REC STOP PAUSE
*
/
Note:
• If you have already programmed a remote control function to a button, the function takes priority over the set up manufacturer code's function.
Controlling a different component from the source component (input) you selected
%
TITLE
ENTER
SOURCE
%
%
DISPLAY MENU
–
SELECT SEARCH CHAPTER
%
! ! $
POWER REC STOP PAUSE
*
/
Note:
• "ERROR" appears in the display window in the following conditions: when pressing a button other than the cursor and ENTER; when pressing more than
one button at once; and when one of MACRO ON/OFF, 10KEY/DSP, PARAMETER/SET MENU is switched to another position.
Remote Control Features
PHONO
CD
DVD
flashes alternately
6CH INPUT
SOUND
+
$
PLAY
#
6CH INPUT
SOUND
+
$
PLAY
#
Select the source component you want to preset by using
1
1
the input buttons.
Press and hold LEARN for about three seconds using a
2
2
ballpoint pen or similar object.
%
Use / to select the name of your component's
3 3
manufacturer.
• You will find the names of most audio-video manufacturers
worldwide in alphabetical order on the display window.
4 Press POWER (or any other button) on the remote control
4
while pointing it at the component to check if you have set
up the code correctly. If the component cannot be
controlled by the remote control, try entering another code
for the same manufacturer.
5
5 Press LEARN to confirm the preset.
• If you want to preset another code for another component
immediately, press ENTER and repeat steps 1 to 4.
Repeat steps 1 and 2 of the procedure in "Setting the
1
1
Manufacturer Code in the Remote Control".
Select a Library (component category) by using / .
2 2
• There are 12 Libraries to set up a manufacturer code; L:TV,
L:CAB (CABLE), L:DBS, L:SAT, L:VCR, L:DVD, L:LD,
L:CD, L:MD, L:TAP (TAPE), L:TUN (TUNER), *L:AMP.
*L:AMP has three codes; YPC, DSP, and NO. "YPC" should be
selected to operate the DSP-AX1. "DSP" is for operating Yamaha
DSP amplifiers other than the DSP-AX1. "NO" is to clear the main
unit control area functions.
Repeat steps 3 and 4 of the procedure in "Setting the
3
3
Manufacturer Code in the Remote Control ".
57