Controls And Functions; Front Panel - Yamaha DSP-Z9 Mode D'emploi

Front panel

1 2 3
PURE DIRECT
2CH/MULTI CH
INPUT SELECTOR
STANDBY
/ON
1 STANDBY/ON
Turns on this unit or sets it to the standby mode. When you
turn on this unit, you will hear a click and there will be a
delay of a few seconds before this unit can reproduce
sound.
Note
In standby mode, this unit consumes a small amount of power in
order to receive infrared-signals from the remote controls.
2 INPUT SELECTOR
Selects the input source you want to listen to or watch.
3 PURE DIRECT 2CH/MULTI CH
Turns on or off the 2-channel/multi-channel PURE
DIRECT mode (see page 43).
4 Remote control sensor
Receives signals from the remote controls.
5 Front panel display
Shows information about the operational status of this
unit.

CONTROLS AND FUNCTIONS

4 5 6 7 8 9
REC OUT/ZONE 2
SOURCE/REMOTE
DTV/LD DVD
CABLE MD/TAPE
SPEAKERS
MULTI CH
INPUT MODE INPUT
A B SAT CD-R
VCR 1 CD
VCR 2 TUNER
PHONO
DVR
VIDEO AUX
SILENT OPTIMIZER
MIC
PHONES S VIDEO
D E F G
0 A B
MULTI JOG BALANCE
DSP
STRAIGHT PROGRAM
TONE
CONTROL
EFFECT
VIDEO AUX
VIDEO AUDIO R OPTICAL
L
H
6 INPUT MODE
Sets the priority for the type of input signal (AUTO,
i.LINK, DTS, DIGITAL, D.D.RF, ANALOG) received
when one component is connected to two or more input
jacks on this unit (see page 44).
7 MULTI CH INPUT
Selects the source connected to the MULTI CH INPUT
jacks. This source takes priority over the source selected
with INPUT SELECTOR (or the input selector buttons on
the remote control).
8 STRAIGHT/EFFECT
Switches the sound fields off or on. When STRAIGHT is
selected, input signals (2-channel or multi-channel) are
output directly from their respective speakers without
effect processing.
9 DSP PROGRAM
Press this button before rotating MULTI JOG to select
sound field programs.
CONTROLS AND FUNCTIONS
C
VOLUME
5