Speaker Impedance Setting; Turning On The Power - Yamaha DSP-Z9 Mode D'emploi

CONNECTIONS

Speaker impedance setting

CAUTION
If you are using 6-ohm speakers, set the impedance to 6
ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1
On the front panel, while holding down
SPEAKERS A, press STANDBY/ON.
"SP Imp. Set" appears on the front panel display for a
few seconds, then "Minimum 8ohms" appears.
SPEAKERS
A
A S P
M i n i m u m
2
Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3
Press STANDBY/ON to exit the setting.
This unit is set to the standby mode.
28
STANDBY
/ON
A I m p . A S e t
A 8 o h m s

Turning on the power

When all connections are complete, turn on this unit's
power.
1
PURE DIRECT
REC OUT/ZONE 2
SOURCE/REMOTE
DTV/LD DVD
CABLE MD/TAPE
SPEAKERS
2CH/MULTI CH
A B SAT CD-R
INPUT SELECTOR
VCR 1 CD
VCR 2 TUNER
DVR PHONO
VIDEO AUX
STANDBY
/ON
SILENT OPTIMIZER
MIC
PHONES
MACRO
TRANSMIT RE-NAME CLEAR LEARN MACRO OFF ON
SYSTEM
1
POWER STANDBY V-AUX TUNER PHONO
CABLE SAT MD/TAPE CD-R CD
DTV/LD VCR 1 VCR 2 DVR DVD
MULTI CH IN
PURE DIRECT
TITLE
ENTER
SOURCE
INPUT MODE TOP EXIT
DISPLAY MENU SOUND
SELECT – +
SEARCH CHAPTER
POWER REC STOP PAUSE PLAY
10KEY AMP STEREO HALL CHURCH JAZZ
1
Press STANDBY/ON (SYSTEM POWER on the
remote controls) to turn on this unit's power.
STANDBY
/ON
Front panel
2
Turn on the video monitor connected to this
unit.
VOLUME
MULTI JOG BALANCE
MULTI CH DSP
INPUT MODE INPUT STRAIGHT PROGRAM
TONE
CONTROL
EFFECT
VIDEO AUX
S VIDEO VIDEO L AUDIO R OPTICAL
SYSTEM
POWER STANDBY
1
ENTER
TOP EXIT
SYSTEM
POWER
or
Remote controls