Reloop RMP-2.5a Mode D'emploi page 29

Les langues disponibles

>> For details on how to save loops, see chapter „Sampling".

The display shows „BANKP.=1". By pressing the Cue/Sample Buttons 1 to 4 -15- in any sequence, an

individualised sequence of up to 12 samples can be programmed.

NOtE:

there are two different play modes: Endless Mode and One Shot Mode. Endless Mode is acti-

vated by pressing the Sampler Button - 17 – once; the sampler LED is continually illuminated.

In Endless Mode the programmed sequence is played endlessly. One Shot Mode is activated

by pressing the Sampler Button - 17 – again. the sampler LED fl ashes. In One Shot Mode the

programmed sequence is played only once. to play the just programmed sequence, press the

Sampler Button -17- (once for Endless Mode / twice for One Shot Mode) and press the Bank pro-

gram Button -9- to start playback. to stop playback, press the Sampler Button -17- again until

the LED goes out.

10. Scratch Effect

Select the scratch effect by pressing the Scratch Button -10-. In playback mode you can now

scratch and stop the track via the inner part of the Jog Wheel -18-, similar to a vinyl record. The

Jog Wheel -18- recognizes the touch of your fi ngers. Press the Scratch Button -10- again to deacti-

vate scratch effect.

NOtE:

If you press the Scratch Button -10- longer than 2 seconds the Scratch-to-Cue function will

be activated. If only the Jog Wheel -18- is being touched, the player returns to the cue point

without going into pause or playback mode. this way it is possible to scratch a track from the

desired cue point. If you press the Scratch Button -10- again, the scratch function will be deac-

tivated. Individually adjust your preferred jog wheel sensitivity. to do so proceed as described

under item 7, sub item 6.

NOtE:

If the Bank program Button -9- is being pressed permanently, it is possible to manually tap the

BpM value with the Scratch Effect Button -10-.

11. Display

The Display -11- indicates all the player's important functions:

A) Track/Folder

Indicates the number of the current track or folder (folder of an MP3-CD).

B) Time Mode

Indicates if the player shows the elapsed time of a track (no indication on the display), the re-

maining time of a track (display shows „Remain") or the remaining time of the entire CD (display

shows „Total Remain"). Use the Time Button -7- to switch between these three modes.

C) Time

Indicates the time of the selected time mode in minutes, seconds and frames (1/75 min.).

D) Playing Address

Visualizes time display and increases or decreases, depending on the selected time mode. Shortly

before a track ends, the entire bar fl ashes.