Publicité
Les langues disponibles
Les langues disponibles
3. Sleep time
Adjustable stand-by time from 0 – 120 minutes.
4. Stop time
Adjustable interval from 0.5 – 12 seconds between the ticker information display repetition.
5. run time
Adjustment of the ticker speed from 50 – 2.000 milliseconds.
6. Jog Sensitivity
Adjustable Jog Wheel's sensitivity from -20 - +20.
7. pitch Bend range
Adjustable pitch bend range from +/-1% - +/-100%. Independently adjustable from master pitch
range.
8. Display Brightness
Adjustable display brightness from 1 – 10.
9. repeat Mode
If repeat mode is turned on, only tracks of the current folder will be played. If repeat is turned off,
you can browse all folders with the Track Encoder -4-.
a. Information Setup
Mode 1: Folder name, ID3 TAG information is displayed in a continuous loop.
Mode 2: Folder name is displayed once, ID3 TAG information is shown repeatedly.
B. Bit rate
Here you can determine whether the bit rate should be displayed or not.
C. MIDI Set
Jog Out:
Via the jog out function you can adjust the delay the jog wheel -18- should take in order to send
MIDI data (Jog Wheel Data Delay) in milliseconds. The delay can be set from 0 – 30 milliseconds. To
do so hold the Shift Button -32- and adjust the desired value via the Track Encoder -4-.
NOtE!
Some DJ softwares are only able to process a limited number of MIDI events per second. For
these cases this adjustment is sensible. a value of 25 milliseconds corresponds to 40 events
per second.
Edit:
Edit On/Off:
If Edit is turned on it is possible to edit MIDI parameters (MIDI Note, MIDI LED). If Edit is turned off,
the RMP-2.5 Alpha sends the preset MIDI commands. Please also see the MIDI map in this manual.
Name:
With the name function it is possible to determine the player's hardware ID. The selected name will
be recognized by the computer.
The following names are available:
RMP-25
RMP-25B
RMP-25C
RMP-25D
RMP-25E
RMP-25F
RMP-25G
RMP-25H
39
Publicité
