Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION
1 Power supply cord
2 Overload safety button
3 Starter switch
4 Lockin screw of clamping ring
5 Clamping ring for fixing position of upper
millstone
6 Plastic hopper lid
7 Feed hopper
8 Airfilter
B. FIRST STARTING WITHOUT MILLING
• Unpack the mill.
• Put it on a clean flat surface, not on a cloth or carpet.
• Unscrew the two bolts (13). Fit flour selector (9) on the body (11) with fixing screws. Air filter
allowing retaining dust has to be in height - see attached drawing -. Screw and block the two
bolts (13).
• Set the adjustable feed inlet control knob (14)
o Maize: total opening
o Wheat: half opening
• Put the feed hopper in its place (7) together with the collection bag or glass jar on the selector.
The best way is done by shipping the bag inside the rubber band and then slipping them both
together on the selector.
• Make sure starter switch (3) is in the "OFF".
ENGLISH
9 Flour selector
10 Twist-off glass or flour collecting bag
11 Mill chamber housing
12 Adjustable upper millstone
13 Thumbs nuts and washer for holding flour
selector
14 Adjustable feed inlet control
15 Switch converter (only on request)
16 Protective casing for axle
Publicité
