Appendix; Troubleshooting; General - Yamaha RX-V465 Mode D'emploi

APPENDIX

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.

General

Problem
This unit fails to turn
on or enters the
standby mode soon
after the power is
turned on.
This unit cannot be
turned off.
No sound.
No picture.
48
En

Troubleshooting

Cause
The power cable is not connected or the
plug is not completely inserted.
(When this unit is turned back on and
"CHECK SP WIRES!" is displayed.) The
protection circuitry has been activated
because this unit was turned on while a
speaker cable was shorted.
The internal microcomputer is frozen due
to an external electric shock (such as
lightning or excessive static electricity) or
by a drop in power supply voltage.
"Audio" in "1 HDMI" of Function Setup
is set to "TV."
A proper audio decoder is not selected.
Incorrect input or output cable
connections.
No appropriate input source has been
selected.
Speaker connections are not secure.
The volume is turned down or muted.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
The HDMI components connected to this
unit do not support the HDCP copy
protection standards.
An appropriate video input is not selected
on the monitor.
The composite output terminals are used
to output a component video signal, or the
COMPONENT VIDEO jacks are used to
output a composite video signal.
Non-standard video signals are input.
Remedy
Connect the power cable properly to an AC wall
outlet.
Make sure that all speaker cables between this unit
and speakers are connected properly.
Disconnect the power cable from the AC wall outlet,
wait about 30 seconds and then plug it in again.
Select a choice for "Audio"
(Func. Setup→1 HDMI→Audio) other than "TV."
Display the OPTION menu and set "Decoder Mode"
to "Auto."
Connect the cables properly. If the problem persists,
the cables may be defective.
Select an appropriate input source with NINPUT l
/ h or the gInput selection keys on the
remote control.
Secure the connections.
Turn up the volume.
Display Signal info of the option menu and check the
input signal format.
If "No Signal" is displayed, check if the playback
component is properly connected to this unit (or a
proper input source is selected).
If "___" is displayed, the input signal in that format
cannot be reproduced by this unit.
Connect HDMI components that support the HDCP
copy protection standards.
Select an appropriate video input on the monitor.
Connect it to the COMPONENT OUT jacks or the
composite output terminals and select an appropriate
video input on the monitor.
Connect the monitor to this unit via the
COMPONENT OUT jacks or the composite output
terminals.
See
page
—
12
—
44
35
14-16
21
11
—
—
57
—
14
14