Publicité
4-43
EMU01460¯
CHANGING GEAR OIL
WARNING
@
G
Be sure the outboard is securely fas-
tened to the transom or a stable stand.
You could be severely injured if the
outboard falls on you.
G
Never get under the lower unit while it
is tilted, even when the tilt-support
lever/knob is locked. Severe injury
could occur if the outboard acciden-
tally falls.
@
1) Tilt the outboard motor so that the oil
drain plug is at the lowest point possible.
2) Place a suitable container under the
gear-case.
3) Remove the oil drain plug 1.
4) Remove the oil level plug 2 to allow the
oil to drain completely.
CAUTION:
@
Inspect the used oil after it has been
drained. If the oil is milky, water is getting
into the gear-case which can cause gear
damage. Consult a Yamaha dealer for
repair of the lower unit seals.
@
NOTE:
@
For disposal of used oil consult your Yamaha
dealer.
@
5) With the outboard motor in a vertical
position, and using a flexible or pressur-
ized filling device, inject the gear oil into
the oil drain plug hole.
Gear oil grade/capacity:
Refer to "SPECIFICATIONS," page 4-1.
6) When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug.
7) Insert and tighten the oil drain plug.
GB
Publicité
Chapitres
