Publicité
d. The product reference: eg: 036608,
e. CE Logo followed by the number 0082, identifi cation
number of the approved body responsible for
GB
production control,
f. Year and week of manufacture,
g. The serial number,
h. pictogram indicating that the user manual must be
read before use.
w. Maximum operating load,
14. Periodic inspection and repair
14. Periodic inspection and repair
An annual periodical inspection is required, but
depending on the frequency of use, environmental
conditions and regulations of the company or the
country of use, periodical inspections may be more
frequent.
Periodical inspections shall be carried out by
an approved and competent technician and in
accordance with the manufacturer's examination
procedures as laid down in the fi le "Verifi cation
procedures for TRACTEL
NOTE:
authorised technician marks the next or last periodic
inspection on the equipment.
Verifi cation of the legibility of the marking on the
product is an integral part of the periodical inspection.
Following the periodical inspection, a certifi cate of
return to service must issued by the approved and
competent technician who performed the periodical
inspection. This return to service must be recorded on
the inspection sheet in the middle of this manual. This
inspection sheet should be retained throughout the life
of the product until it is scrapped.
After arresting a fall, this textile product must be
dismantled and destroyed, even if there is no visible
alteration.
TRACTEL
textile PPE equipments as harnesses,
®
lanyards, ropes and energy absorbers, TRACTEL
Mechanical PPE equipments as stopcable™ and
stopfor™ fall-arresters, blocfor™ self-retracting fall-
arresters, and the TRACTEL
without restrictions from their manufacturing date
providing that:
– A normal use is made in accordance with the
instructions manual,
– A periodical inspection, which must be accomplished
at least once a year by an approved and competent
8
PPE".
®
Tractel
recommends
15. Lifespan
15. Lifespan
lifelines can be used
®
technician. At the end of this periodical inspection,
the PPE must be certifi ed fi t to return to service,
in writing,
– Instructions manual procedures for storage and
transport are strictly met.
When disposing of the product, all components must
be recycled with preliminary sorting of components
into metallic and synthetic materials. These materials
must be recycled by specialist bodies. During
disposal, dismantling to separate components should
be achieved by a duly trained person.
that
the
®
16. Disposal
16. Disposal
Publicité
