18
*THESE CHECKS SHOULD INCLUDE:
1. BOOM: Check the attachment of the boom to the mast. Make sure
there is only minimal side movement of the boom and the boom
is free to rotate on the boom bearing.
2. MAST: Check the operation of the mast-locking device. Make sure
the mast fully engages into the socket. Check the bottom actuator.
3. ACTUATOR: The actuator should require no
maintenance other than checking for correct operation and
listening for unusual noise.
4. POWER PACK: Check the function of the
emergency stop button and emergency lower.
5. BATTERIES: The batteries are housed in the power
pack and should not require maintenance other than the regular
charging as detailed in the charging instructions. Check that the
connections remain clean.
6. LEG ADJUSTMENT: Check the legs operate in both full
extensions (inward/outward).
7. CASTORS: Check all castors for firm attachment to the legs.
Check for free rotation of the castor and the wheels.
8. CLEANING: Clean with ordinary soap and water and/or any hard
surface disinfectant. Harsh chemical cleaners or abrasives should
be avoided as these may damage the surface finish of the lift.
Avoid wetting any of the electrical parts.
9. LOAD TEST: The load test should be carried out in accordance
with the manufacturer's test procedures. It is strongly recommended
the testing is carried out by an authorised service dealer.
10. BASE AND WHEELS: Ensure base is even and level
(all four wheels are on the floor).
11. SLINGS: Check for wear and fraying.
12. LUBRICATION: Oil pivot joints, including mast and boom
connections, pedal assembly, spreader bar joint (only if required
13. HAND SET: Ensure plugged fully into controller.
294000.10022 Rev. B
E n g l i s h
).