AMIX SNA 60 Manuel D'utilisation page 61

Procedure :
1 - Open the upper hood ( plexiglas).
2 - Enter the code Priority (1052 by default)).
3 - Select page 4 using of
4 - Select "Code" modification function ( see list previous page) using of key 1 of numerical keyboard .
5 - Enter using of numerical keyboard (1) your new code.
6 - Validate using of key
7 - Enter a second times your new code.
8 - Validate using of key
9 - On screen, validate a last time to finish procedure in progress.
Note : If the key
operation.
10 -  If your new code is valid, information "modified code !!!" displays during around 5 secconds.
 If your new code is not valid, imformation " code !!!" displays during around 5 seconds.
Remark :
- If the code entered is invalid, the system allows you to renew your entry.
- When SNA 60 asks you to enter the code number of Priority 2 , press key Page 1 displays a code as "masked"
correspondent. By sending this code, we will be able to give you the code associated Priority 2.
- At any time when entering your code, press "ESCAPE" replace the entry procedure code in its original position.
2°) Use of characteristic measure function of measurement chain:
It allows to standardize
set off system.
The level picked up by the sensor is indicated as a information on LCD display.
Procedure :
1 - Open the upper hood (plexiglas).
2 - Enter the code Priority 1
3 - Select page 4
4 - Select
5 - Wait at the end of measurement sequence. The test level is displayed as information during 5 seconds.
6 -
ESCAPE
It is necessary to carry out this test with the wired hood set up on CAP 60, because reflexions about this hood
must be take account for the measure.
AMIX
ANNEX 2: SETTING MODES RECAP
PAGE
4
ENTER
ENTER
ESCAPE has been pressed, you must take again editing in stage 4 and start again the
Function 5
the measurement chain in order to check it during the control. This function must be used by the fitter at
PAGE
4
using of
5
( "measure chain" function) .
to leave page 4.
29
SNA 60