AMIX SNA 60 Manuel D'utilisation page 60

Time parameter setting :
1 - Open the upper hood (plexiglas) .
2 - Enter the code Priority 1
3 - Select page 3 using of
4 - Select the time parameter to modify (see list above).
5 - Enter using of numerical keyboard (1) the new desired value.
6 -
Remarks : If the key
the operation .
Attention : If you display an only time parameter, you must leave by the key
C ) Management functions.
Management functions allow user communicating with the system in order to capture necessary information for a good
analysis and a good setting of sound regulation. They gather all functions allowing an easy modification of sensitive datas to
epuipment. (code, factory setting).
Détail of management function.
1°) Use of modification function of code priority 1 or priority 2:
The modification function of codes Priority 1 and 2 allows to modify acess code of system. You must enter 2 times the new code
before validate in order to replace existing code.
Remarks : If the 2 entered codes are differents, the current code is not modified.
AMIX
ANNEX 2: SETTING MODES RECAP
PAGE
3
to save the new value or
ENTER
ESCAPE
P4 : Management function
1  Code change Priority 1.
2  Code change Priority 2.
3  Automatic hour change.
4  Undefined.
5  Characteristic measure of measurement chain
6  Functioning in case of sensor default.
7  Relay functioning.
8  Authorization to cut-off.
9  Undefined.
10  Undefined.
Functions 1 & 2
to cancel.
ESCAPE
has been pressed, you must take again editing in stage 4 and start again
28
ESCAPE
.
SNA 60