Condenser - Leica DM1000 Mode D'emploi

6. Assembly

6.2 Condenser

• If present, screw the condenser head into the
condenser
• Using the condenser height adjuster (9.3), turn
the condenser holder (fig. 8) completely
downward
• Unscrew the clamping screw for the con-
denser (9.2) far enough so that the condenser
can be inserted from the front
• From the front, insert the condenser into the
condenser holder as far as it will go; on the
underside of the condenser, there is an orien-
tation pin (7.1), which must be located in the
guiding notch (8.1)
• Pull the condenser's clamping screw (9.2) so
that the condenser is locked in place
Fig. 7 Underside of condenser (example CL/PH)
1 Orientation pin
2 Auxiliary condenser lens LS
1
2
18
The condenser must be centered before using
the microscope.
→ Köhler illumination p. 28.
Fig. 8
1 Guiding notch
Fig. 9
1 Condenser centering bolts
2 Clamping screw for condenser
3 Condenser height adjuster
1
3
1
Note:
Condenser holder
1
Condenser holder
3
2
1