Message Lists - Sony VPL-GH10 Mode D'emploi

Message Lists

Note
If "Status" is set to "All Off" in the Setup
displayed except for the message marked with an asterisk (*). (1 page 46)
Warning messages
Message
High temp.! Lamp off in 1
min.
Frequency is out of range!
Please replace the Lamp/
Filter.
Please clean the filter.
Please clean the filter. Have
you finished? Yes No*
Projector temperature is
high. Cooling Setting
should be "High" if
projector is being used at
high altitude.
menu, the warning/caution messages are not
Cause and Remedy
c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes.
(1 page 13)
c Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector. (1 page 67)
c It is time to replace the lamp. Replace the lamp. (1 page 61)
c Also, replace the air filter too. Restart cleaning the ventilation
holes (intake). (1 page 61)
If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process. (1 page 61)
Note
To clear this message, press any button either on the remote control
or the control panel of the projector once.
c It is time to clean the air filter. Clean the air filter. (1 page 64)
Note
To clear this message, press any button either on the remote control
or the control panel of the projector once.
c It is time to clean the air filter. Clean the air filter. (1 page 64)
c If you cleaned the air filter, select "Yes." If you did not clean the
air filter, select "No."
Note
This message is displayed even when "Status" is set to "All Off."
c Check to ensure that the ventilation holes on the unit are not
covered. (1 page 13)
c When using the projector at high altitude, set the "Cooling
Setting" to "High." (1 page 46)
Note
When temperature inside the projector remains high, the "Cooling
Setting" is switched to "High" in 1 minute, then the fan speed
increases.
59
GB