Connections And Preparations; Unpacking - Sony VPL-GH10 Mode D'emploi

Connections and Preparations

This section describes how to install the projector and screen, how to connect the
equipment from which you project the picture.

Unpacking

Check the carton to make sure it contains the following items:
• Remote control (1) and
Size AA (R6) manganese batteries (2)
• AC power cord (1)
• ImageDirector3 CD-ROM (1)
• Operating Instructions (this manual)
Installing batteries
Two size AA (R6) batteries are supplied for the remote control. To avoid risk of explosion,
use size AA (R6) manganese or alkaline batteries.
Inserting the batteries into the remote control
Push and slide
to open.
Caution about handling the remote control
• Handle the remote control with care. Do not drop or step on it, or spill liquid of any kind
onto it.
• Do not place the remote control in a location near a heat source, a place subject to direct
sunlight, or a damp room.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer.
When you dispose of the battery, you must obey the law in the relative area or country.
Insert the batteries E side first as shown in the illustration.
Inserting them forcibly or with the polarities reversed may
cause a short circuit and may generate heat.
11
GB